![]() ![]() I was wondering if any of you had the same problem and have come up with a solution that could remedy this issue. On one occasion the final product came in from the vendor, and it was a mess, inside corners were blown out in large circles, and outside corners were rounded off into large circles. I have to do different things for different vendors, and as I said this only works 50 percent of the time, and I will not know if it worked or not, until the vendor starts complaining about open files or not. This works sometimes depending on the program that the vendor is using. ![]() One of the methods I have to use is to import the DXF file into Corel Draw X3 and remove all the extra nodes that the program will allow me to delete without changing the shape of the item. When I try to remove the nodes in autocad the shape changes. Our router program and some of the programs that our vendors use (waterjet and plasma cutter) programs that have major trouble with the amount of control points (nodes) that are required to hold that shape as it should be. Some of the shapes are created from splines and or polylines. Here is the question I have: I have to sometimes make files for a router table, water jets, and plasma cutters. I am not sure if this is the right place to put this, so if the admin or moderators need to move it, that is fine. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |